Description
Product Details This charger is a high-efficiency, wall-mount AC/DC switching power adapter designed to deliver a regulated 24V 3.75A (90W) DC output. It uses a universal 100–240VAC, 50/60Hz input stage, allowing deployment in most regions that use standard AC mains (with suitable plug compatibility and approvals). The adapter is housed in a compact black enclosure with a UL 2-pin AC plug and an integrated DC output cable of approximately 1.2m. Internal design includes high-frequency switching, EMI filtering, and multiple protection circuits to ensure stable, low-ripple output for sensitive loads. With efficiency level VI, low standby power, and compliance to ETL 62368-1 and FCC Part 15B, this adapter is suitable for 24V powered equipment that requires consistent performance, electrical safety, and adherence to modern energy-efficiency standards. Usage Notes & Safety Instructions General Use Use only on AC mains within 90–264VAC, 50/60Hz. Ensure the connected device is rated for 24V DC and does not exceed 3.75A / 90W. Plug the adapter firmly into a properly grounded, standard AC outlet. Environment Operate the adapter within 0–40°C ambient temperature and 5–90% RH, non-condensing. Avoid placing it near heat sources, in direct sunlight, or in very humid or dusty environments. For storage, keep within –20 to +65°C and away from corrosive or conductive contaminants. Connection & Handling Do not pull the adapter by the DC cable; hold the housing when unplugging from the wall. Avoid bending or sharply twisting the DC cord; repeated mechanical stress may damage the cable. Ensure good ventilation around the adapter; do not cover it with cloth or place it in confined, unventilated spaces. Safety & Protection If the adapter shuts down due to over-current, short-circuit, or over-voltage, remove the load and unplug from AC. After the fault is corrected, reconnect; the unit is designed for auto-recovery. Do not attempt to open, modify, or repair the adapter—this can defeat safety isolation and void compliance. Do not use the adapter if the housing is cracked, the cable is damaged, or you notice unusual smell, noise, or excessive heat. Intended Use Designed for equipment requiring 24V DC supply up to 90W, such as certain industrial devices, consumer electronics, and LED or control systems that match the rating. Indoor use is strongly recommended; if used near moisture, ensure it is protected from water spray and condensation.
Reviews
There are no reviews yet.